Dryer Repair Cost: Not Heating in Canada
By Oleksandr Potapenko · 2026-11-16 · How we research prices

The dryer tumbles, the drum turns, the clothes come out damp. It is the most common dryer complaint there is, and it is also one of the cheapest to fix, because four times out of five the cause is one of three small parts. The trick is finding which one before you pay for all three.
Appliance Forever in the GTA, writing from its own service calls, says four out of five no-heat calls come down to a blown thermal fuse, a burnt-out heating element on an electric dryer, or a failed gas valve coil on a gas dryer. Angi puts the wider picture at $100 to $430 US for a dryer repair, averaging $180, with a no-heat repair specifically at $80 to $420 US. HomeAdvisor's range is similar at $100 to $400 US. The Canadian numbers line up once converted. At 1.40 Canadian dollars per US dollar, Angi's no-heat band becomes roughly $110 to $590 Canadian, which is wide because it spans a $15 fuse and a $500 board. The Canadian shop prices narrow it usefully. Appliance Forever's median no-heat dryer job over the past year was $197 Canadian, and its typical breakdown is a thermal fuse plus vent clean at $89 to $130, a heating element replacement at $210 to $280, gas valve coils at $210 to $270, and an igniter at $190 to $240. TrueFix in Toronto quotes a thermal fuse at $90 to $180 including labour, a heating element at $150 to $300, and a thermostat at $120 to $220. Toronto Refrigeration quotes most common dryer repairs at $100 to $350 Canadian, with a heating element at $150 to $280 and a thermal fuse at $100 to $180. Ottawa shops quote a heating element at $180 to $320 and a thermal fuse at $150 to $250. There is no single Canadian national price series, so these Canadian dollar figures are estimates built from the converted US guides plus these named Canadian shops, and the shops agree with each other far more closely than the US guides agree with each other.
Start with the vent, because it is the root cause behind most of the rest. A clogged dryer vent is the number one cause of a dryer that runs without heat, and it is also a fire risk. Toronto Fire Services records around 39 dryer fires in the city every year, and a blocked vent is the usual story behind them. Clean the lint trap after every load, and have the vent duct cleaned professionally if drying times have crept up. TrueFix puts a full vent cleaning at $130 to $250 in Toronto, and Ottawa shops quote $100 to $180. That is money well spent even when the dryer still heats, because a clear vent is what keeps the next thermal fuse alive.
The thermal fuse is the part most people have never heard of and most often need. It is a small one-shot safety device, usually mounted on the blower housing, that melts open if the exhaust temperature exceeds about 190 to 205 degrees Fahrenheit (88 to 96 degrees Celsius). The part itself costs about $10 to $20, and a replacement fuse is $10 to $20 at a parts counter. What you pay the technician for is opening the dryer and, critically, finding why it blew. A thermal fuse almost always blows because the vent was blocked, and replacing the fuse without clearing the vent means the new fuse blows again within weeks. That is why the GTA shops quote the fuse and the vent clean together, at $89 to $130, rather than the fuse alone.
On an electric dryer, the next suspect is the heating element, a coil that corrodes or breaks open. It is diagnosable in about 15 minutes with a $15 multimeter, checking continuity across the coil, and the part runs $40 to $90. The professional replacement in Toronto is $150 to $300 including parts and labour, and $210 to $280 in the GTA. On a gas dryer there is no heating element. Instead there is an igniter and a set of gas valve coils, and the igniter is the part that fails most. Gas valve coils run $210 to $270 installed in the GTA, and an igniter $190 to $240. Gas work past the thermal fuse is not a do-it-yourself job: in Ontario it must be done by a TSSA-certified technician, and the same rule applies in spirit everywhere else in Canada. Never bypass a thermal fuse or any other safety device to test a dryer. That is how fires start.
The decision rule is straightforward, and the GTA shops state it plainly. A thermal fuse or heating element on a dryer under 10 years old is almost always worth fixing: $210 to extend the life of a $700 to $1,200 dryer is the right maths. A heating element plus a control board at $420 to $560 on a dryer 10 to 15 years old is borderline and depends on the cabinet, the drum bearings and the door seal. A dryer over 15 years old with a multi-component failure is a replacement, with a new entry-level dryer at $650 to $900 installed and a matched Samsung or LG set at $1,400 to $2,000. HomeAdvisor puts dryers at 13 to 15 years of life, which matches that judgement. Use the 50 percent rule as the backstop: if the repair costs more than half the price of a comparable new dryer, replace it.
Before the technician leaves, ask them to run a full cycle and check the exhaust temperature and airflow at the outside vent. Ask what failed, whether the vent was the root cause, and what the warranty is on parts and labour. Then check the quote on the RepairPrice home calculator (home-calculator.php), and read Washing Machine Repair Cost in Canada for the matching half of the laundry pair, Appliance Repair Visit Cost in Canada: Repair or Replace? for the diagnostic fee, and Oven and Stove Repair Cost in Canada if the gas line serving the dryer is also feeding the range.
Common questions:
How much does it cost to fix a dryer that won't heat in Canada? Most no-heat repairs fall between $90 and $300 Canadian. Appliance Forever in the GTA quotes a thermal fuse plus vent clean at $89 to $130, a heating element at $210 to $280, and gas valve coils at $210 to $270, with a median no-heat job of $197. Converted from Angi's US $80 to $420 at 1.40, the wider band is about $110 to $590.
What causes a dryer to tumble but not heat? Four times out of five it is a blown thermal fuse, a burnt-out heating element on an electric dryer, or a failed gas valve coil on a gas dryer, according to Appliance Forever in the GTA. A clogged vent is the root cause behind most blown fuses, so the vent must be cleared or the new fuse will blow again.
Can I fix a dryer that won't heat myself? A thermal fuse and a heating element on an electric dryer are diagnosable with a multimeter and are DIY-fixable for many homeowners, with parts at roughly $10 to $20 for a fuse and $40 to $90 for an element. Gas dryer work past the thermal fuse is not: in Ontario it requires a TSSA-certified technician. Never bypass a safety device.
When should I replace my dryer instead of repairing it? Use the 50 percent rule and the age test together. A dryer under 10 years old with a $150 to $300 repair is a fix. A dryer over 15 years old, or one needing a $420 to $560 multi-part repair, is usually a replacement. HomeAdvisor puts dryer lifespan at 13 to 15 years.
| Problem | Typical repair range (CAD) | Likely fix |
|---|---|---|
| Tumbles, no heat (electric) | 150β400 | Element, thermal fuse, thermostat |
| Tumbles, no heat (gas) | 250β450 | Igniter, gas valve coils |
| Drying time doubled | 150β350 | Vent cleaning, airflow check |
| Motor / control board | 400β800 | Weigh against replacement if old |