Eavestrough / Gutter Installation Cost in Canada

By Oleksandr Potapenko · 2026-11-16 · How we research prices

Installer fitting new aluminum eavestroughs on a house roof edge

Eavestroughs are the cheapest insurance on your house, and the most ignored until the basement floods. Every square foot of roof collects rain and snowmelt and delivers it to the edge, and the eavestrough is the only thing standing between that water and your foundation. When it works, you never think about it. When it sags, clogs or pulls away from the fascia, water pours down the wall, saturates the soil beside the foundation, and feeds the basement leaks and frost damage that cost ten times as much to fix. In a country with heavy spring melt and summer downpours, that is not a minor system. It is the drainage system.

RenoQuotes, in its 2026 Canadian gutter guide, puts installation at $3 to $15 per linear foot for most materials, or roughly $600 to $3,000 for an average home, with aluminum at $5 to $13 and copper at $18 to $40 per linear foot. HomeStars, in its 2026 gutter guides, gives a wider band: $4 to $40 per linear foot for materials, with labour adding $6 to $15, and aluminum at $5 to $15 and copper at $15 to $40. The two guides agree on aluminum and copper but disagree on the low end, because RenoQuotes prices complete installed systems on straightforward homes while HomeStars separates material from labour and includes premium profiles. The more recent local numbers are higher, and they matter. EavesArmour, an Ontario installer, prices 2026 Ontario work at $12 to $22 per linear foot for seamless aluminum, $8 to $14 for vinyl, $22 to $35 for galvanized steel and $40 to $80 for copper. Rapid Roofing Solutions, in Calgary, prices 2026 seamless aluminum at $11 to $17 per linear foot for 5-inch trough and $13 to $22 for 6-inch, with a typical home at $2,300 to $4,100. Both local guides blame the same cause: a 25 percent tariff on imported steel and aluminum, with aluminum trim manufacturers announcing roughly 10 percent increases going into 2026. The honest 2026 planning range for Canada is therefore $8 to $22 per linear foot installed for seamless aluminum, or about $1,500 to $4,500 for a typical house with 150 to 200 linear feet, with vinyl cheaper, steel higher, and copper in a different league. There is no single Canadian national price series for eavestroughs, so these are estimates from named Canadian guides, and a quote from 2024 will be 30 to 40 percent low.

Size is the decision most homeowners never hear about, and it is the one that matters most. The standard Canadian eavestrough is 5 inches wide, and it is fine for a small bungalow with a simple roof. A two-storey house with a large or steep roof collects far more water per linear foot of trough, and in a heavy downpour a 5-inch trough overflows even when it is clean. A 6-inch trough carries roughly 40 percent more water, and the upgrade costs only $2 to $5 more per linear foot. Calgary and Ontario installers both now recommend 6-inch troughs as the default for two-storey homes, and the cost of the upgrade, a few hundred dollars on a whole house, is trivial next to the cost of one basement flood. Downspouts matter just as much: one downspout per 30 to 40 feet of trough is the rule of thumb, and a long run with a single downspout will overflow at the far end no matter how clean it is. Where the downspout lands is the other half of the system. A downspout that dumps water a foot from the foundation is worse than useless, because it concentrates the entire roof's water at the worst possible spot. Extensions that carry water 4 to 6 feet away, or a buried drain line, cost $150 to $600 each and are the cheapest foundation protection you can buy.

Material choice is a lifespan decision disguised as a price decision. Vinyl is cheapest at $8 to $14 per linear foot installed in Ontario, but it turns brittle in Canadian cold, sags under snow load, and lasts 10 to 15 years. Seamless aluminum is the Canadian standard for a reason: it does not rust, it handles freeze-thaw well, it is formed on site in runs up to 30 metres with no seams to leak, and it lasts 20 to 30 years. The standard spec is 0.027 to 0.032 inch aluminum, and the thicker gauge is worth the small premium on a house with heavy snow. Galvanized steel is heavier, handles impact better in high-snowfall areas like Barrie and Collingwood, and lasts 25 to 35 years, but it must be kept painted or it rusts at cut edges and fastener holes. Copper is a heritage choice: it will outlast the house at $25 to $80 per linear foot, but it is a decision about appearance, not about drainage. Whatever the material, ask whether the quote includes hangers, end caps, mitre joints and downspouts, because some low quotes exclude them and the real price appears later.

The repair-versus-replace rule is simple. Repair when the trough is under 15 years old and the problem is local: a leaking corner, a sagging section, a downspout that has come loose. Replace when the system is over 20 years old, when seams leak in several places, when the trough has pulled away from the fascia, or when the fascia behind it is rotted, because a new trough on a rotten fascia is money thrown away. Replace the whole run rather than patching section by section, because a seamless trough has no joints to fail and a patched sectional trough has a joint every 10 feet. If the fascia is rotted, read Soffit and Fascia Replacement Cost in Canada before you approve the eavestrough quote, because the two jobs share scaffolding and access, and doing them together saves hundreds. And if you are adding guards, read Gutter Guard Installation Cost in Canada first: guards added during a replacement cost $3 to $8 per linear foot in incremental labour, versus $12 to $18 as a separate visit later, according to EavesArmour.

Before you sign, ask three questions. Is the trough seamless and formed on site, and what gauge is the aluminum? How many downspouts are included, and where will each one discharge? And is the fascia sound, or will it need repair before the new trough goes up? Get three written quotes, check that each one carries WSIB coverage and liability insurance, and compare them line by line with the RepairPrice home calculator at home-calculator.php. A quote that is 30 percent below the others is almost always thinner aluminum, fewer downspouts, or missing disposal of the old system. Clean the troughs twice a year, in spring and after leaf fall, and your $3,000 eavestrough will protect a $600,000 house for a quarter of a century.

Common questions:

How much does eavestrough installation cost in Canada? RenoQuotes puts most homes at $600 to $3,000, but 2026 local guides are higher: EavesArmour prices Ontario seamless aluminum at $12 to $22 per linear foot, and Rapid Roofing Solutions prices Calgary at $11 to $17 for 5-inch and $13 to $22 for 6-inch. Budget roughly $1,500 to $4,500 for a typical house in 2026.

Should I get 5-inch or 6-inch eavestroughs? Choose 6-inch for a two-storey house or a large or steep roof: it carries about 40 percent more water for only $2 to $5 more per linear foot. Five-inch is fine for a small bungalow with a simple roof, but it overflows in heavy rain on a big roof even when clean.

How long do aluminum eavestroughs last? Seamless aluminum lasts 20 to 30 years in Canada, according to EavesArmour and RenoQuotes, while vinyl lasts 10 to 15 years and copper lasts 50 years or more. Lifespan depends on gauge, snow load and cleaning: a trough full of wet leaves rots its hangers and sags years early.

How often should eavestroughs be cleaned? Twice a year at minimum: once in spring after the snow melts, and once after leaf fall in autumn. Homes under large trees may need a third cleaning in midsummer, and a clogged trough is the single most common cause of water overflowing onto the foundation.

OptionTypical range (CAD)Notes
Aluminum seamless, per linear foot$8–$22Most common; 5-inch low end, 6-inch high end (EavesArmour / Rapid Roofing)
Vinyl sectional, per linear foot$8–$1410–15 year life; brittle in cold
Galvanized steel, per linear foot$12–$3525–35 years; needs paint to prevent rust
Copper, per linear foot$25–$80Premium / heritage; 50+ years
Typical house, complete$1,500–$4,500150–200 ft, downspouts included
Downspout extension / drain line$150–$600 eachMoves water 4–6 ft from foundation

About the author

Oleksandr Potapenko

Oleksandr Potapenko β€” founder of RepairPrice, a Canadian price-transparency platform for car and home repairs, based in Edmonton, Alberta.

Check the fair price

See what this repair should cost for your car in seconds.

→

Check my quote

Got a number from a shop? Find out in 30 seconds if it is fair.

→

Related guides