Subfloor Repair and Replacement Cost in Canada

By Oleksandr Potapenko · 2026-11-16 · How we research prices

Contractor repairing a damaged subfloor with plywood sheets and tools

A squeaky floor is a message, and the message is almost never about the floor you walk on. It is about the layer underneath it — the plywood or OSB subfloor, and the joists below that — and reading the symptom correctly is the difference between a $300 screw-down and a $3,000 rebuild. This guide works backwards from what you can hear and feel, because that is how a good contractor diagnoses the job before anyone lifts a board.

Start with the symptom. A squeak in one spot, worse in winter, that goes quiet when someone stands on it: that is usually a subfloor that has pulled away from a joist as the wood dried and shrank, and the fix is often just screwing the subfloor tightly back down to the joists with construction adhesive — the cheapest repair in this guide, and the one most often skipped because the finished floor hides it. A soft spot that gives underfoot near a bathroom, kitchen, or exterior wall: that is usually rot, and it means water has been reaching the wood quietly for years. A dip across a whole room, or a floor that feels bouncy across a wide span: that is usually the joists, not the subfloor, and it is a structural question, not a flooring question. A floor that is out of level by half an inch across a room: that is a levelling job, not a replacement job, and confusing the two is how people pay for new plywood they did not need.

Diagnosis comes before demolition, and a contractor who wants to tear up the floor before looking from below is a contractor to question. When basement or crawlspace access exists, a good inspection checks from underneath first: water stains on the joists, the condition of the subfloor from below, and whether the subfloor or the joists are actually moving. From above, a moisture meter reading and a straightedge across the floor tell the rest. The rule is simple: fix the water source before replacing the subfloor, or the new sheets will rot exactly like the old ones. Bathroom leaks, dishwasher and washing-machine overflows, and ice damming at exterior walls are the usual culprits in Canadian houses, and they rot subfloors quietly for years before anyone notices a soft spot.

On price, the published sources are unusually consistent, which is reassuring for a job with so many unknowns. Angi's October 2026 guide puts subfloor replacement at $3 to $10 US per square foot, with most homeowners paying $900 to $3,000 US for an average 300-square-foot room and a national average of $1,560 US per job — the "$1,560 per square foot" figure in Angi's text is an obvious typo for per job, since their own per-room range contradicts it. Fixr and Homewyse, cited in the 2026 cost compilations, agree on the same $3 to $10 US band, and HomeGuide prices a new subfloor alone, without the finished floor, at $2.20 to $4.75 US per square foot. The Canadian figures carry the standard caveat: there is no single Canadian national price series for subfloor work, so the ranges below are estimates converted from those verified American figures at 1.40 Canadian dollars per US dollar. Converted, $3 to $10 US becomes roughly $4.20 to $14 Canadian per square foot, and a realistic Canadian planning range for full replacement is $4 to $10 per square foot, plus the new finished floor on top — which is quoted separately by the flooring installer and can cost more than the subfloor work itself. A localized repair, such as re-screwing a squeaky area or replacing a few rotted sheets, typically runs $400 to $1,400 Canadian, and small patches under 50 square feet often carry a minimum charge of $400 to $800 Canadian for the job regardless of size.

The material ladder is worth knowing because it is the one choice you actually get to make. Standard 3/4-inch CDX plywood costs $1 to $1.50 US per square foot for material alone. OSB, oriented strand board, is slightly cheaper at $0.80 to $1.25 US, and it is the default in most new Canadian construction — but it swells more than plywood when it gets wet, which matters in a house with a leak history. Premium engineered subfloor panels such as AdvanTech cost $2 to $3 US per square foot for material, resist moisture, and do not swell the way OSB does; on a bathroom or laundry-room floor, that premium is the cheapest insurance in the whole job. Moisture-resistant panels such as DRIcore run up to $9 US per square foot and are a different product entirely, designed for basements over concrete. Angi's material table puts basic plywood at $2.50 to $3.50 US per square foot installed as a panel, which is consistent once labour is included. For a bathroom, laundry room, or any floor with a wet history, the decision rule is to spend the extra on the moisture-resistant panel and skip the premium finish elsewhere — the subfloor is the wrong place to save $200.

Levelling deserves its own paragraph because it is the most commonly misquoted line in flooring. Levelling with shims or self-levelling compound typically adds $500 to $2,500 Canadian depending on area and how far out of level the floor is, and the 2026 guides price levelling or patching alone at $1 to $3 US per square foot. Self-levelling compound is the right fix for a concrete slab or a floor that is low in the middle; shimming is the right fix for a wood floor that is high at the joists. Neither one fixes rot, and neither one fixes joists — and a contractor who proposes levelling compound over a soft, rotted section is selling you a smooth floor that will crack within a year.

Joist work is where the numbers jump, and where you should slow down. Sistering a joist — bolting a new joist alongside a damaged one — is a contained repair, typically $500 to $2,000 Canadian for a limited area. Full floor joist repair is a different job entirely: Angi's October 2026 guide puts the national average at $6,000 US, with most homeowners paying $4,000 to $12,000 US and $10 to $67 US per square foot depending on the extent of the damage, accessibility, and whether surrounding materials need replacement. If a quote mentions joists at all, ask whether it is sistering or structural repair, get a second opinion, and check whether a building permit is required — in the GTA, structural subfloor and joist work can trigger a permit of $180 to $500 or more, while standard flooring needs none. Subfloor work is disruptive because the finished floor above must come up, so the smartest move is to combine it with a planned flooring replacement: if you are already re-flooring, read "Hardwood Floor Installation Cost in Canada", "Vinyl Plank Flooring Installation Cost in Canada", or "Laminate Flooring Installation Cost in Canada" for the floor that will go on top, and get the quote with joist repairs, subfloor material, levelling, and disposal listed separately so nothing falls between two trades. Confirm who reinstalls the finished floor — the subfloor contractor or the flooring installer — before work starts, and run the combined totals through the RepairPrice home calculator (home-calculator.php) so the subfloor line does not ambush the flooring budget.

Common questions:

How much does subfloor replacement cost in Canada? Typically $4 to $10 Canadian per square foot for full replacement, or $900 to $3,000 US for an average 300-square-foot room according to Angi's 2026 data, converted at 1.40. A localized repair of a few sheets or a squeaky area runs $400 to $1,400 Canadian, and the new finished floor on top is quoted separately.

What causes squeaky floors? Usually the subfloor has pulled away from a joist as wood dried and shrank, so the boards rub and move underfoot. Re-screwing the subfloor tightly to the joists with construction adhesive fixes most squeaks; a squeak combined with a soft spot usually means rot or water damage instead.

How do I know if my subfloor needs replacing? Soft spots underfoot, visible rot or water stains from below, a floor that dips across a room, or a moisture meter reading that stays high all point to replacement. A single squeak with no softness usually needs screws, not new plywood — get the diagnosis from below before anyone demolishes.

Is plywood or OSB better for a subfloor? Plywood costs $1 to $1.50 US per square foot for material and handles occasional wetting better; OSB is slightly cheaper at $0.80 to $1.25 US but swells more when wet. Premium moisture-resistant panels at $2 to $3 US are the best choice for bathrooms and laundry rooms.

JobTypical range (CAD)What moves the price
Localized repair (squeaks, few sheets)$400–$1,400Area, access from below
Full replacement, per sq ft$4–$10Material, joist condition
Levelling (shims, compound)$500–$2,500Area, out-of-level amount
Joist repair / sistering$500–$2,000Extent of damage
Finished floor reinstallQuoted separatelyFloor type, area

About the author

Oleksandr Potapenko

Oleksandr Potapenko — founder of RepairPrice, a Canadian price-transparency platform for car and home repairs, based in Edmonton, Alberta.

Check the fair price

See what this repair should cost for your car in seconds.

→

Check my quote

Got a number from a shop? Find out in 30 seconds if it is fair.

→

Related guides