Driveshaft Replacement Cost in Canada
By Oleksandr Potapenko · 2026-11-16 · How we research prices

The vibration starts at highway speed and gets worse the faster you go. Or there is a clunk every time you pull away from a light, or shift from park into drive. Or a squeak that follows road speed, not engine speed. Any one of these can be a driveshaft — the long tube that carries power from the transmission to the rear wheels on a rear-wheel-drive or four-wheel-drive car — and the repair ranges from a $350 joint to a $1,500 shaft, depending on which part of it failed.
The driveshaft itself is simple: a steel or aluminium tube with a universal joint at each end, a slip yoke that lets it change length as the suspension moves, and on longer shafts a centre support bearing that holds the middle up. The joints are the wear items. Universal joints, or U-joints, allow the shaft to articulate as the suspension moves, and over time they develop play, seize, or dry out. The centre bearing wears and hums. The shaft itself can bend or go out of balance after an impact. ZekeParts' 2026 guide puts a complete driveshaft replacement at $400 to $1,500 including parts and labour as a general range, and that width is honest: a short shaft on a common truck is a different job from a two-piece shaft with a centre bearing on a luxury SUV. RepairPal's component figures narrow the picture for the serviceable parts: a U-joint replacement runs $331 to $406, including $176 to $179 in parts and $155 to $227 in labour, and a centre or carrier bearing runs $395 to $517. YourMechanic lists a 2012 Ford F-150 driveshaft service at about $736, including $590 in parts and $146 in labour. Oards' 2026 guide puts a rear-wheel-drive or four-wheel-drive long shaft at $600 to $1,100, with parts at $250 to $750 and labour at $300 to $500. In Canada, at an independent shop, a fair planning range is about $550 to $1,400 for a complete driveshaft replacement on a mainstream truck or SUV, with a single U-joint or centre bearing at roughly $400 to $650 Canadian. The spread is mostly parts: a new OEM shaft costs multiples of a remanufactured one, and a used shaft from a wrecker is cheaper still.
The symptom map is what saves you money, because three different failures feel similar from the driver's seat and cost very different amounts. A vibration that increases with road speed, felt through the floor or the seat, and noticeable from about 65 km/h upward, points at the shaft: worn U-joints, a worn centre bearing, or an imbalanced shaft. A clunk on take-off, on gear changes, or when shifting from park to drive or reverse points at worn U-joints or a worn slip yoke. A constant squeak or hum at road speed points at a dry U-joint or a worn centre bearing. Clicking on turns, by contrast, is usually a CV axle, not the driveshaft — covered in our guide CV Axle Replacement Cost in Canada — and a vibration that follows engine speed rather than road speed is usually an engine or transmission mount, covered in our guide Transmission Mount and Cooler Line Repair Cost. A good shop will put the car on a hoist, grab the shaft, and check for play in the joints by hand before quoting anything; a shaft with play is a shaft that needs work, and a shaft without play needs a different diagnosis.
The decision rule is about the joint versus the shaft. If the tube is straight, the yoke and splines are sound, and only a U-joint or the centre bearing is worn, replace the component: $331 to $406 for a U-joint or $395 to $517 for a centre bearing in RepairPal's figures is a fraction of a complete shaft. If the shaft tube is cracked or bent, the yoke or splines are severely damaged, or the vehicle uses non-serviceable joints, replace the complete assembly — and ask whether a remanufactured shaft is available, because it is often half the price of new OEM with a comparable warranty. If the shaft is out of balance rather than worn, a professional balancing is sometimes possible for $100 to $300, and it is worth asking about before authorising a replacement. And if the car is a front-wheel-drive car, be careful with the words: what many people call the driveshaft on a front-wheel-drive car is actually the CV axle, and the repair and the price are different.
One safety note, because this part fails differently from most. A driveshaft that breaks while driving can drop, dig into the road, and pole-vault the car — it is one of the few failures that can cause a loss of control rather than just a breakdown. If you notice visible cracks, disconnection, or severe damage, do not drive the car; arrange a tow and an inspection. A clunk that is getting worse week by week is the same warning on a slower schedule. Get the fair price for your exact vehicle from the RepairPrice calculator at calculator.php before you book, and ask the shop whether the quote is for a joint, a bearing, or the complete shaft — those are three different jobs, and the invoice should say which one you are buying.
Common questions:
Q: How much does a driveshaft replacement cost in Canada? A: About $550 to $1,400 for a complete replacement on a mainstream truck or SUV at an independent shop. A single U-joint runs roughly $400 to $650 Canadian, and a centre bearing about the same. American guides put a complete shaft at $400 to $1,500 in US dollars.
Q: What are the symptoms of a bad driveshaft? A: Vibration that increases with road speed, a clunk on take-off or when shifting into drive or reverse, a squeaking or humming noise at road speed, and in bad cases difficulty turning or the car not moving at all.
Q: Can I drive with a bad driveshaft? A: Briefly and gently to a shop, if the damage is limited to a worn joint. If the shaft is cracked, bent, or disconnected, do not drive it — have it towed. A broken driveshaft can cause a loss of control.
Q: Is it cheaper to replace a U-joint or the whole driveshaft? A: Almost always the U-joint, if the shaft itself is sound. RepairPal puts a U-joint at $331 to $406 and a centre bearing at $395 to $517 in US dollars, against $400 to $1,500 for a complete shaft. Replace the whole shaft only if the tube, yoke, or splines are damaged.
| Service | Typical range (CAD) | Notes |
|---|---|---|
| Driveshaft replacement, complete | $550–$1,400 | US guides $400–$1,500; parts tier drives the spread |
| U-joint replacement | $400–$650 | RepairPal US $331–$406; replace the joint if the tube is sound |
| Centre / carrier bearing | $400–$650 | RepairPal US $395–$517 |
| Diagnostic scan | $95–$130 | Scan plus inspection on a hoist |
| CV axle, each, car (closest shaft job) | $320–$585 | Axle $150–$350 + ~1.8 h labour |
| Transmission mount, car | $220–$395 | Often done with shaft work |
| Wheel balancing, set of 4 | $55–$110 | After shaft work, if needed |